![]() Please note that the tool that you receive after placing an online order may be in a used but operable condition due to the nature of the Loan-A-Tool® program.Short answer battery jump starter autozone:ĪutoZone is a retailer that offers several brands of portable jump starters, including DieHard and Stanley. Do not wear ties or loose clothing when working on your vehicle.įREE Loan-A-Tool® program requires returnable deposit. Should electrolyte get on your body or clothing, neutralize it immediately with a solution of baking soda and water. Always wear gloves and safety glasses and other personal protection equipment, and work in a well-ventilated area. ![]() Sulfuric acid is caustic and can burn clothing and skin or cause blindness. Use caution when working with automotive batteries. Always disconnect the negative battery cable before servicing an electrical application on the vehicle to protect its electrical circuits in the event that a wire is accidentally pierced or grounded. ![]() Always chock your wheels prior to lifting a vehicle. Refer to the service manual for specific diagnostic, repair and tool information for your particular vehicle. Information is accurate and true to the best of AutoZone’s knowledge, however, there may be omissions, errors or mistakes.īe sure to consult your owner’s manual, a repair guide, an AutoZoner at a store near you, or a licensed, professional mechanic for vehicle-specific repair information. If you just turn your car off as soon as you jump-start it, it probably won’t turn back on.Īdvice, how-to guides, and car care information featured on and AutoZone Advice & How-To’s are presented as helpful resources for general maintenance and automotive repairs from a general perspective only and should be used at your own risk. ![]() Once your car is running, you’ll need to run it for at least 15 to 30 minutes so that the alternator has time to charge the battery. Instead, you’ll just have to press a button, then turn on your car. If using a portable jump starter, the process is essentially the same, but without a second car. Once the car is running, disconnect the negative cables followed by the positive cables. Turn on the car with the working battery, then turn on the car with the dead battery. Then clamp one end of the black cable to the negative terminal on the working battery, and clamp the other end to a metal bracket on the car with the dead battery. Clamp one end of the red jumper cables to the positive terminal on the dead battery, then clamp the other end to the positive terminal on the working battery. If using another car, park that car with the hood near your car’s battery. To do this, you’ll need a pair of jumper cables and a second car, or you’ll need a portable jump starter. The other way to charge a battery is by jump-starting your car. Reconnect the car’s battery cables, and again be sure to do the positive cable first, and the negative cable second.Once the charging is complete, turn off the charger and remove the cables from the battery terminals.Then turn the battery charger on, and it will begin the process of charging the battery.With the charger turned off, connect the positive cable from the charger to the battery’s positive terminal, then do the same with the negative cable and negative terminal.Different chargers might have different instructions, so read through the manual first, but in general, they all work pretty much the same. Now it’s time to use your battery charger.Next, clean the battery terminals using a battery brush or a battery cleaning solution.You’ll probably need a socket wrench when disconnecting the cables.Make sure that the cables are not resting near each other, as you don’t want them touching.With all of the electronics in the car turned off, disconnect the negative battery cable, then disconnect the positive battery cable.The first is the traditional way: by using a battery charger.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |